![]() ![]() Checked the frequency channel of my router, which was Channel 7 (~2.4GHz) and I ran the following commands: sudo ip link set wlp4s0 downĪnd it worked. That frequency is on a channel that my wireless network adapter doesn't have (it only supports 2.4GHz) and that my router network doesn't occupy. This could be observed with iwconfig wlp4s0 which gave me the following output: wlp4s0 IEEE 802.11 ESSID: The only downside was that TP Link doesnt have a Windows 10 driver yet and with the default Microsoft driver, the card would lose signal every 15 minutes or so. So the device drivers existed, the wifi card itself could physically see the networks, but upon trying to connect those networks would never be found because the interface was configured to the wrong frequency. For whatever reason, the particular card I had was not being configured with the correct wifi frequency/channel. Model : Hardware Version : Firmware Version : ISP : Hello, Im using this network card on Windows 10 and for some reason is not connecting to my 5Ghz. However, I discovered my issue with the other card, as it was driving me insane. Feature Filter: All Troubleshooting User Application Requirement Q&A of functional explanation or specification parameters. That being said, I actually did end up purchasing a different wifi card that better suited my needs, one that uses the iwlwifi driver instead. Best driver for Tp-link TL-WDN4800 on Windows 10 Help : r/techsupport r/techsupport r/techsupport 7 yr. ![]() Currently, TP-LINK has no driver for Windows 8.1. Okay, so I believe I've found the source of the problem. Model : TL-WDN4800 Hardware Version : V1 Firmware Version : ISP : Hello Tech. I have absolutely 0 idea what to do about this. Should "Access Point" be something other than "Not-Associated?" If so how do I change it?Īlso, running iwlist scan half the time results in No scan results, but then after a few tries it returns the relevant information. Please refer to your TP-Link regional website to determine product availability. Mode:Managed Access Point: Not-Associated Tx-Power=19 dBm Result of iwconfig: wlp4s0 IEEE 802.11 ESSID: In a domestic environm ent, this product may cause radio interference, in which case the user may be required to take adequate measures. When attempting to connect, dmesg gives the following result: wlp4s0: authenticate with I think it may have something to do with the persistence of the connection. I don't believe it's a driver issue, as all driver checks come up fine. Ubuntu version is 18.04, the card is a Qualcomm Atheros and the driver for my card is ath9k. ![]() I don't have access to ethernet, and trying to connect using the Network Manager GUI results in it timing out, saying "Activation of network connection failed." It runs perfectly fine on the same machine with Windows 10. I've put a clean install of Ubuntu on my PC, but I can't get it to connect to the wifi. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |